|
YAMAHA
02RV2.0 数字调音台
GENERAL
SPECIFICATIONS
Number of scene memories 99
Sampling Frequency Internal
External 44.1kHz, 48kHz, 88.2kHz, 96kHz
Normal rate 44.1kHz-10% - 48kHz+6%
Double rate 88.2kHz-10% - 96kHz+6%
Signal Delay
(CH INPUT to STEREO OUT) Fs=48kHz
Fs=96kHz ≤ 1.9ms
≤ 0.7ms
Fader 100mm motorized with touch sense x 25
Fader Resolution
Master faders, Stereo fader +10--96,∞-dB (256 steps/100mm )
0--130,∞-db(256 steps/100mm)
Total Harmonic Distortion *1
(CH INPUT to STEREO OUT)
Input Gain = Min.
Fs=48(96)kHz
≤0.05% 20Hz to 20(40)kHz @+14dB into 600 ohms
≤0.01% 1kHz @+18dB into 600 ohms
Frequency Response
(CH INPUT to STEREO OUT) Fs=48kHz
Fs=96kHz 0.5,-1.5dB 20Hz - 20kHz @+4dB into 600 ohms
0.5,-1.5dB 20Hz - 40kHz @+4dB into 600 ohms
Dynamic Range
(maximum level to noise level) DA Converter (STEREO OUT)
AD+DA (to STEREO OUT)
110dB typ., Fs=48 or 96kHz
105dB typ., Fs=48 or 96kHz
Hum & Noise *2
(20Hz-20kHz)
Rs=150 ohms
Input Gain=max.
Input Pad=0dB
Input Pad=0dB
Input Sensitivity=-60dB -128dB (EIN : Equivalent Input Noise)
-92dB (Residual Output Noise) @STEREO OUT
STEREO OUT off
-92dB (96dB S/N) @STEREO OUT
STEREO fader at nominal level and all CH INPUT faders at minimum level
-64dB (68dB S/N) @STEREO OUT
STEREO fader at nominal level and one CH INPUT fader at nominal level
Maximum Voltage Gain 74 [48]dB from CH INPUT1-16 [17-24] to STEREO
OUT/OMNI (BUS) OUT
74 [48]dB from CH INPUT1-16 [17-24] to OMNI (AUX) OUT (via pre input
fader)
74 [48]dB from CH INPUT1-16 [17-24] to CONTROL ROOM MONITOR OUT
(via STEREO bus)
*1 Total Harmonic Distortion is measured with a 6dB/octave filter
@80kHz.
*2 Hum & Noise are measured with a 6dB/ octave filter @12.7kHz
equivalent to a 20kHz filter with infinite dB/octave attenuation.
Power Requirements Power Requirements U.S./Canada 120 V 200W 60Hz.
Dimensions Height 9.41"(13.85") (including the MB02R96)
Depth 27.44"
Width 26.25"(27.55")(including the SP02R96)
Weight 74.95 lbs
Operating free-air
temperature range 10-35°C
Storage temperature range -20-60°C
Accessories AC Cable
CD-ROM (Studio manager)
Options Digital audio interface card (MY8,MY4 series)
PEAK METER BRIDGE: MB02R96
SIDE PANEL: SP02R96
LIBRARIES
Effect libraries (EFFECT1-4) Number of factory presets
Number of user libraries 52 (EFFECT3-8 :44)
76
Compressor libraries Number of factory presets
Number of user libraries 36
92
Gate libraries Number of factory presets
Number of user libraries 4
124
EQ libraries Number of factory presets
Number of user libraries 40
160
Channel libraries Number of factory presets
Number of user libraries 2
127
Surround Monitor libraries Number of factory presets
Number of user libraries 1
32
Input patch libraries Number of factory presets
Number of user libraries 1
32
Output patch libraries Number of factory presets
Number of user libraries 1
32
Bus to stereo libraries Number of factory presets
Number of user libraries
1
32
ANALOG INPUT CHARACTERISTICS
Input
Terminals Position Actual
Load
Impedance For Use
with
Nominal Input Level Connector
in
Console
PAD
SW GAIN
TRIM Sensitivity
*1 Nominal Max
before
clip
CH INPUT
A/B
1-16 0dB -60dB 3k A:50-600
Lines
B:600
Lines -70dB (0.245mV) -60dB (0.775mV) -46dB (3.88mV) A:XLR-3-31 type
(Balanced) *2
B:Phone Jack (TRS) (Balanced) *3
26dB -16
(+10)dB -26dB (38.8mV) -16dB (0.123V) -2dB (616mV)
0dB (775mV) +10dB (2.45V) +24dB (12.28V)
CH INPUT
17-24 -35dB
4k 600
Lines -70dB (0.245mV) -60dB (0.775mV) -46dB (3.88mV) Phone Jack (TRS)
(Balanced) *3
+10dB 0dB (775mV) +10dB (2.45V) +24dB (12.28V)
CH INSERT
in
1-16 10k 600
Lines -6dB (388mV) +4dB (1.23 V) +18dB (6.16V) Phone Jack (Unbalanced)
*4
2TR IN
ANALOG 1(L,R) 10k 600
Lines +4dB (1.23V) +4dB (1.23 V) +18dB (6.16V) Phone Jack (TRS)
(Balanced) *3
2TR IN
ANALOG 2(L,R) 10k 600
Lines -10dBV (0.316 V) -10dBV (0.316 V) +4dBV (1.58V) RCA Pin Jack
(Unbalanced)
*1. Sensitivity is the lowest level that will produce the nominal output
level when the unit is set to maximum gain. (all faders and level
controls are maximum position.)
*2. XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*3. Phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*4. CH INSERT IN/OUT phone jacks are unbalanced. (Tip=OUTPUT,
Ring=INPUT, Sleeve=GND)
• In these specifications, when dB represents a specific voltage,
0dB is referenced to 0.775 Vrms.
• For 2TR IN ANALOG 2 levels, 0dBV is referenced to 1.00 Vrms.
• All AD converters are 24 bit linear, 128times oversampling.
• +48V DC (phantom power) is supplied to CH INPUT (1-16) XLR type
connectors via each individual switch.
ANALOG OUTPUT CHARACTERISTICS
Output Terminals Actual Source Impedance
For Use
With
Nominal
GAIN SW Output Level
Connector in Console
Nominal Max before clip
STEREO OUT
(L,R) 600K
10K
Lines - -10dBV (0.316V) +4dBV (1.58V) RCA Pin Jack (Unbalanced)
150 600K
Lines - +4dB (1.23 V) +18dB (6.16 V)
XLR-3-32 type (Balanced) *1
STUDIO MONITOR OUT
(L,R) 150k
10K
Lines - +4dB (1.23 V) +18dB (6.16 V) Phone Jack (TRS) (Balanced) *2
C-R MONITOR OUT (L,R) 150k
600K
Lines - +4dB (1.23 V) +18dB (6.16 V) Phone Jack (TRS) (Balanced) *2
OMNI OUT 1-8 150 10K
Lines +18dB (defalt) +4dB (1.23 V) +18dB (6.16 V) Phone Jack (TRS)
(Balanced) *2
+4dB (1.23V) -10dB(0.245V) +4dB (1.23V)
CH INSERT OUT 1-16 600 10K
Lines - +4dB (1.23 V) +18dB (6.16 V) Phone Jack (Unbalanced) *4
PHONES 100 8K
Lines - 4mW 25mW Stereo Phone Jack (TRS)
(Unbalanced)*3
40K
Lines - 12mW 75mW
*1. XLR-3-32 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*2. Phone jack are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*3. PHONES stereo phone jack is unbalanced. (Tip=LEFT, Ring=RIGHT,
Sleeve=GND)
*4. CH INSERT IN/OUT phone jacks are unbalanced. (Tip=OUTPUT,
Ring=INPUT, Sleeve=GND)
• STEREO OUT [L, R], 0dBV is referenced to 1.00 Vrms.
• In these specifications, when dB represents a specific voltage,
0dB is referenced to 0.775 Vrms.
• All output (except INSERT OUT 1-16) DA converters are 24bit,
128times oversampling.
DIGITAL INPUT CHARACTERISTICS
Terminal Format Data Length Level Connector in Console
2TR IN
DIGITAL
1 AES/EBU 24-BIT RS422 XLR-3-31 type (Balanced)*1
2 IEC-60958 24-BIT 0.5Vpp/75ohm RCA Pin Jack
3 IEC-60958 24-BIT 0.5Vpp/75ohm RCA Pin jack
CASCADE IN - - RS422 D-SUB Half Pitch Connector 68P (Female)
*1. XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
|
|
02R96 新款数字调音台
